In the DFIG Tem>0 and S<0 than the mode of operation and speed of the machine is Generator, ωm> ωs Motor, ωm> ωs Generator, ωm< ωs Generator, ωm> ωs
Question
In the DFIG Tem>0 and S<0 than the mode of operation and speed of the machine is Generator, ωm> ωs Motor, ωm> ωs Generator, ωm< ωs Generator, ωm> ωs
Solution
The question seems to be about the operation mode and speed of a Doubly Fed Induction Generator (DFIG).
In a DFIG, the rotor is connected to the grid via a converter which allows for control of the rotor's speed and power factor. The speed of the machine (ωm) and the synchronous speed (ωs) determine the mode of operation.
-
If the torque (Tem) is greater than 0 and the slip (S) is less than 0, the DFIG operates as a generator. This means that it is converting mechanical power into electrical power.
-
If ωm is greater than ωs, the machine is operating above synchronous speed. This is typically the case when the DFIG is operating as a generator.
-
If ωm is less than ωs, the machine is operating below synchronous speed. This is typically the case when the DFIG is operating as a motor, converting electrical power into mechanical power.
So, based on the given conditions (Tem>0 and S<0), the mode of operation would be a generator and the speed of the machine would be ωm> ωs.
Similar Questions
DFIG is a __________ type of machine. Squirrel Cage Induction Slip Ring Induction Both Squirrel Cage and Slip Ring Induction
The speed of a conventional motor is controlled by the frequency of the current and_______ a. resistance b. voltage c. the load on it d. number of poles
A 50 hp, 240 V, 4 poles, 60 Hz, Delta connected, three phase induction motor, ifR 1 =0,4 ohm, R’ 2 =0,6 ohm, X 1 =1,0 ohm, X’ 2 =1,0 ohm, n s =1800 and n=1710.Find the following quantities:a) I 1 =I’ 2 =?b) t=?c) I st =?d) t st =?e) t max =?f) S max =?g) Sketch thetorque-speedcharacteristic
10 kW, 6-pole, 50 Hz, 3- phase induction motor has linear torque-slip characteristicsbetween zero torque and maximum torque. The slip at which maximum torque of 520 Nmoccurs is 0.2. For mechanical losses of 600 W, find the speed at which motor would run whiledelivering rated shaft power
he output of a factory can be no higher than the output of the slowest machine, the constraint of the system.Group startsTrue or False
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.