To disable the preset delay time value of the timer count after start and again start up-counting from ZERO which point is usedans.RTOEnableResetRetentive Timer Previous Marked for Review Next

Mention the roll over value (in hex and decimal) of the timer for each of the following cases:1. Timer 0 Normal mode2. Timer 1 normal mode

LLDP has an additional timer called the Interface Reinitialisation Delay. What is the default time in seconds?Question 7Select one:2 Seconds25 seconds5 seconds30 secondsClear my choice

If the crystal frequency is 4.5 MHz, determine the time for setting the timer flag for mode 3 if count in TH0 is 9CH.1 point264 micro sec.50 micro sec.50 ms.100 ms.

.Identify any three instructions that should be highly privileged(prioritize) by OS from the given options.a. Set value of timer.b. Read the clock.c. Clear memory.d. Issue a trap instruction.e. Turn off interrupts.f. Modify entries in device-status table.g. Switch from user to kernel mode

Configure TIMER 2 of PIC microcontroller for 1 ms delay