When would the Cisco IOS image held in ROM be used to boot the router?
Question
When would the Cisco IOS image held in ROM be used to boot the router?
Solution
The Cisco IOS image held in ROM would be used to boot the router in the following scenarios:
-
During a power-on startup (also known as a cold start), the router first uses the IOS image in ROM to boot up. This is the default behavior.
-
If the IOS image in flash memory is missing or corrupted, the router will fall back to the IOS image in ROM. This is a fail-safe mechanism to ensure the router can still function even if the primary IOS image is not available.
-
The router can also be manually configured to boot from the IOS image in ROM. This is typically done for troubleshooting purposes, such as when there's an issue with the IOS image in flash memory.
-
In some older models of Cisco routers, the IOS image in ROM is used for password recovery procedures.
Similar Questions
When a router is powered on, where will the router first search for a valid IOS image to load by default?
During troubleshooting procedures, from which location will most Cisco routers load a limited IOS?
What is the effect of using the Router# copy running-config startup-config command on a router?The contents of ROM will change.The contents of RAM will change.The contents of flash will change.The contents of NVRAM will change.
Using default settings, what is the next step in the switch boot sequence after the IOS loads from flash?
23.0% completeQuestionA tech has an Android tablet that no longer receives updates due to its age. Learning that a custom firmware with new features is available, what does the tech require to install the image?A.JailbreakB.Root accessC.SideloadD.Wipe
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.