In Unix/Linux, you can use the `sleep` command to delay the execution of a command. Here are the steps:

1. Open your terminal.

2. If you want to delay a command execution by 10 minutes, you can use the `sleep` command followed by the number of seconds you want to delay. Since there are 60 seconds in a minute, 10 minutes would be 600 seconds. So, you would type `sleep 600`.

3. After typing `sleep 600`, you can then type the command you want to execute. For example, if you want to execute the `ls` command after a delay of 10 minutes, you would type `sleep 600 && ls`.

4. Press Enter to start the timer. After 10 minutes, the `ls` command will be executed.

Please note that the `&&` symbol is used to chain commands in Unix/Linux. The second command (`ls` in this case) will only be executed if the first command (`sleep 600` in this case) finishes successfully.

Question

In Unix/Linux, you can use the `sleep` command to delay the execution of a command. Here are the steps:

1. Open your terminal.

2. If you want to delay a command execution by 10 minutes, you can use the `sleep` command followed by the number of seconds you want to delay. Since there are 60 seconds in a minute, 10 minutes would be 600 seconds. So, you would type `sleep 600`.

3. After typing `sleep 600`, you can then type the command you want to execute. For example, if you want to execute the `ls` command after a delay of 10 minutes, you would type `sleep 600 && ls`.

4. Press Enter to start the timer. After 10 minutes, the `ls` command will be executed.

Please note that the `&&` symbol is used to chain commands in Unix/Linux. The second command (`ls` in this case) will only be executed if the first command (`sleep 600` in this case) finishes successfully.

Knowee AI · Accepted Answer

In Unix/Linux, you can use the `sleep` command to delay the execution of a command. Here are the steps:

1. Open your terminal.

2. If you want to delay a command execution by 10 minutes, you can use the `sleep` command followed by the number of seconds you want to delay. Since there are 60 seconds in a minute, 10 minutes would be 600 seconds. So, you would type `sleep 600`.

3. After typing `sleep 600`, you can then type the command you want to execute. For example, if you want to execute the `ls` command after a delay of 10 minutes, you would type `sleep 600 && ls`.

4. Press Enter to start the timer. After 10 minutes, the `ls` command will be executed.

Please note that the `&&` symbol is used to chain commands in Unix/Linux. The second command (`ls` in this case) will only be executed if the first command (`sleep 600` in this case) finishes successfully.

12. What is the command to delay a command execution by 10mins?

Question

Solution

Similar Questions

Upgrade your grade with Knowee