Which channel group mode must you configure on both ports to enable a static EtherChannel?Question 10Select one:ActiveNewOnPassiveAuto

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?SW2(config-if-range)# channel-group 1 mode onSW2(config-if-range)# channel-group 1 mode desirableSW2(config-if-range)# channel-group 1 mode activeSW2(config-if-range)# channel-group 1 mode passive

Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?

What command must firstly be configured on an interface to enable layer 3 EtherChannel?Question 13Select one:switchport mode trunkswitchport access no switchportno shutdown

Which three settings can be configured under the Host Onboarding Port Assignment menu by a network administrator? (Choose three.)Administrative States (Up/Down)Authentication TemplateConnected Device TypePort SpeedScalable GroupSSID

Refer to the exhibit. The administrator tried to create an EtherChannel between S1 and the other two switches via the commands that are shown, but was unsuccessful. What is the problem?Traffic can only be sent to two different switches if EtherChannel is implemented on Layer 3 switches.​Traffic cannot be sent to two different switches, but only to two different devices like an EtherChannel-enabled server and a switch.​Traffic cannot be sent to two different switches through the same EtherChannel link.Traffic can only be sent to two different switches if EtherChannel is implemented on Gigabit Ethernet interfaces.​