Refer to the exhibit. The administrator tried to create an EtherChannel between S1 and the other two switches via the commands that are shown, but was unsuccessful. What is the problem?Traffic can only be sent to two different switches if EtherChannel is implemented on Layer 3 switches.Traffic cannot be sent to two different switches, but only to two different devices like an EtherChannel-enabled server and a switch.Traffic cannot be sent to two different switches through the same EtherChannel link.Traffic can only be sent to two different switches if EtherChannel is implemented on Gigabit Ethernet interfaces.
Question
Refer to the exhibit. The administrator tried to create an EtherChannel between S1 and the other two switches via the commands that are shown, but was unsuccessful. What is the problem?Traffic can only be sent to two different switches if EtherChannel is implemented on Layer 3 switches.Traffic cannot be sent to two different switches, but only to two different devices like an EtherChannel-enabled server and a switch.Traffic cannot be sent to two different switches through the same EtherChannel link.Traffic can only be sent to two different switches if EtherChannel is implemented on Gigabit Ethernet interfaces.
Solution
The problem is that traffic cannot be sent to two different switches through the same EtherChannel link. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches. It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers. An EtherChannel can be created from between two and eight active Fast, Gigabit or 10-Gigabit Ethernet ports, with an additional one to eight inactive (failover) ports which become active as the other active ports fail. However, these links need to connect to the same switch on the other end.
Similar Questions
A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?SW2(config-if-range)# channel-group 1 mode onSW2(config-if-range)# channel-group 1 mode desirableSW2(config-if-range)# channel-group 1 mode activeSW2(config-if-range)# channel-group 1 mode passive
What command must firstly be configured on an interface to enable layer 3 EtherChannel?Question 13Select one:switchport mode trunkswitchport access no switchportno shutdown
Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?
You are configuring an EtherChannel interface to carry multiple VLANs using a Cisco proprietary protocol. Drag and drop the relevant configuration commands in order.
Which channel group mode must you configure on both ports to enable a static EtherChannel?Question 10Select one:ActiveNewOnPassiveAuto
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.