In packet tracer, “Physical Device View” does not contain ________.Select the correct optionReload Math Equations Original Size Zoom Out Front view Zoom In

Did you try changing the width of the viewport? Was there a visible change in the output?1 pointYes, and there were changesNoYes, but no visible changes

When directly connecting two devices in Packet Tracer, you must use a copper __________ cable to connect the devices. (Please type your answer all in lower case. If your answer includes multiple words, use a hyphen between them with no spaces. Example: "secure" or "secure-network")

Packet Tracer Step-by-Step GuidePART 1If you cannot figure out how to install and configure Packet Tracer, first watch the twointroduction videos in the course page.Start Packet Tracer.1. Take a few minutes to become familiar with the interface.2. Click on Switches -> (2950-24). Then click on the topology area (centre). A Switchwill appear (Switch0).3. Click on End Devices -> Generic (PC-PT). Then click on the topology area. A PC willappear (PC0).4. Click on Connections -> Copper Straight-Through.a. Click on PC0. Select FastEthernet0.b. Click on Switch. Select FastEthernet0/1.c. A link will appear between the hub and the PC. This is an Ethernetconnection.5. Similarly add another PC (PC1) and connect them to the Switch.6. Click on PC0. You will see a window with 4 panes (Physical, Config, Desktop andSoftware/Services). You can switch on/off the pc and configure varioussoftware/hardware parameters through this window.7. Click on Desktop -> IP Configurationa. Select ‘Static’b. Enter the IP Address 192.168.1.1c. Enter the subnet mask 255.255.255.0d. Close the window8. Similarly, set the IP addresses 192.168.1.2 to PC1.9. Click on PC0a. Go to Desktop -> Command Promptb. Type ipconfig end enter.c. You will see the IP configuration of the computer.d. Type ping 192.168.1.2 and entere. You will see echo replies from 192.168.1.2 (PC1).f. You have just tested the network connection between PC0 and PC1.10. Similarly, test the network connectivity from PC1 to PC0.11. You have just implemented a simple network with 2 PCs.PART 21. Click on Routers. Select Router (1941). Add it to the topology.2. Click on End Devices again -> Generic (Server-PT). Add it to the topology (Set IP:192.168.2.1)3. Connect GigabitEthernet0/0 and GigabitEthernet0/1 interfaces of the Router0 toSwitch0 and Server0 respectively. (Note: use Connections -> Copper CrossOver forconnecting Router to Server).4. Click on Router1 - Go to Configa. Click on GigabitEthernet0/0. Set the IP address to 192.168.1.254 and thesubnet mask to 255.255.255.0 then Select ‘On.’ This will bring up the routerinterface.b. Click on GigabitEthernet0/1. Set the IP address to 192.168.2.254 and thesubnet mask to 255.255.255.0 then Select ‘On’c. You have just configured a router connected to two networks with theminimum required configuration.

Refer to the exhibit. An instructor wants to show a few prebuilt Packet Tracer sample labs in class. Which menu option would the instructor use to access a sample lab?FileEditOptionsViewToolsExtensions

The diameter of a field of view is 4.7mm. 4 cells fit across the diameter under 4x objective magnification.What is the actual size of each cell?2019 Atomi QuestionA(Choice A)2.94μmB(Choice B)29.4μmC(Choice C)0.0294μmD(Choice D)0.294μm