What is the output ripple frequency of a half-wave rectifier circuit when fed with a 50 Hz AC signal? Group of answer choices100 Hz35.35 Hz50 Hz25 Hz
Question
What is the output ripple frequency of a half-wave rectifier circuit when fed with a 50 Hz AC signal? Group of answer choices100 Hz35.35 Hz50 Hz25 Hz
Solution
The output ripple frequency of a half-wave rectifier is the same as the frequency of the input AC signal. This is because a half-wave rectifier only allows one half (either positive or negative) of the AC signal to pass through.
So, if the input AC signal is 50 Hz, the output ripple frequency of the half-wave rectifier will also be 50 Hz. Therefore, the correct answer is 50 Hz.
Similar Questions
If input frequency is 50Hz then ripple frequency of bridge full wave rectifier will be equal to _________(1 Point)200Hz50Hz45Hz100Hz
A half-wave rectifier circuit operates from a supply of 230 V (r.m.s.) at 50 Hz. The load consists of a 100 resistor in parallel with a capacitor of 1000 F. Neglecting the resistance of the rectifier element calculatethe mean output voltage and the r.m.s. value of the ripple voltage.
You are asked to design a full-wave rectifier DC supply that can supply 5 V with a DC current of 47 mA, similar to the circuit shown below. The DC supply will use a step-down transformer connected to an Australian wall outlet (50 Hz). If the maximum ripple amplitude of the supply is specified at 0.83 V, what is the minimum value of the capacitor C1 (in mF) that is required ? Specify your answer to two decimal places.
A half wave rectifier uses capacitor of 680 µF in parallel withload resistance of 200 Ω. If the average output voltage is 28 V.Calculate peak-to-peak voltage, AC voltage present at the output,and ripple facto
Ripple factor for full-wave rectifier is
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.