Which of these is a safe thing to do when driving through a tunnel? Turn on your headlights and remove your sunglasses. Drive through the tunnel as quickly as possible. Turn off your headlights and put on your sunglasses. Turn on your hazard lights when entering.
Question
Which of these is a safe thing to do when driving through a tunnel? Turn on your headlights and remove your sunglasses. Drive through the tunnel as quickly as possible. Turn off your headlights and put on your sunglasses. Turn on your hazard lights when entering.
Solution
The safest thing to do when driving through a tunnel is to turn on your headlights and remove your sunglasses. This is because turning on your headlights will help you see better in the darker environment of the tunnel, and removing your sunglasses will prevent any further reduction in visibility. Driving through the tunnel as quickly as possible can be dangerous due to the reduced visibility and potential for other drivers to not be able to react in time. Turning off your headlights and putting on your sunglasses would only reduce visibility further, making it more dangerous. Turning on your hazard lights when entering could confuse other drivers and isn't typically necessary unless you're experiencing a problem with your vehicle.
Similar Questions
The BEST advice for driving in fog is ______________.A. Turn on your high-beam headlightsB. Drive about ten miles below the posted speed limitC. Wear sunglasses to reduce fog glareD. Not to drive in fog at all
What is the most important and safest thing a driver should do just before driving away? Lock the doors. Walk around the vehicle. Put on the safety belt and put away electronics. Make sure the gas tank is full.
When driving on a highway at night, you should never use your high-beam headlights if you are:
When driving on a highway at night, you should never use your high-beam headlights if you are:Options: Slowing down for a turn. Traveling on a road with no median. Going downhill. Following another car.
What are the steps for successful passing?A) Signal intent, check for blind spots, scan for hazardsB) Check for blind spots, scan for hazards, establish a safe response for hazardsC) Identify an end-of-pass gap to pull back into lane, scan for hazards, establish a safe response for hazardsD) Scan for hazards, check for blind spots, establish a safe response for hazards
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.