What command would you use to remove EtherChannel from an interface?Question 8Select one:remove channel-group nno interface port-channel nno channel-group nno channel-member n

What command must firstly be configured on an interface to enable layer 3 EtherChannel?Question 13Select one:switchport mode trunkswitchport access no switchportno shutdown

Which command should you enter on an interface in a vendor-neutral EtherChannel so that it will be selected first to transmit packets?Question 12Select one:lacp system-priority 1024lacp port-priority 1024pagp system-priority 1024pagp port-priority 1024

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?SW2(config-if-range)# channel-group 1 mode onSW2(config-if-range)# channel-group 1 mode desirableSW2(config-if-range)# channel-group 1 mode activeSW2(config-if-range)# channel-group 1 mode passive

Which channel group mode must you configure on both ports to enable a static EtherChannel?Question 10Select one:ActiveNewOnPassiveAuto

You are configuring an EtherChannel interface to carry multiple VLANs using a Cisco proprietary protocol. Drag and drop the relevant configuration commands in order.