Knowee
Questions
Features
Study Tools

You are configuring an EtherChannel interface to carry multiple VLANs using a Cisco proprietary protocol. Drag and drop the relevant configuration commands in order.

Question

You are configuring an EtherChannel interface to carry multiple VLANs using a Cisco proprietary protocol. Drag and drop the relevant configuration commands in order.

🧐 Not the exact question you are looking for?Go ask a question

Solution

  1. "configure terminal" - Enter global configuration mode.
  2. "interface port-channel 1" - Enter interface configuration mode for the EtherChannel bundle.
  3. "switchport mode trunk" - Set the EtherChannel interface to trunk mode to allow multiple VLANs.
  4. "switchport trunk encapsulation dot1q" - Set the trunking protocol to 802.1Q.
  5. "exit" - Exit interface configuration mode.
  6. "interface range fastEthernet 0/1 - 2" - Enter interface range configuration mode for the physical interfaces that will be part of the EtherChannel.
  7. "channel-group 1 mode desirable" - Assign the interfaces to EtherChannel bundle 1 and set the channel group mode to desirable, which means the interfaces will actively attempt to form an EtherChannel.
  8. "exit" - Exit interface range configuration mode.
  9. "exit" - Exit global configuration mode.

This problem has been solved

Similar Questions

Using a network simulation tool, create a network with three VLANs and show how to assignports to each VLAN

Refer to the exhibit. The administrator tried to create an EtherChannel between S1 and the other two switches via the commands that are shown, but was unsuccessful. What is the problem?Traffic can only be sent to two different switches if EtherChannel is implemented on Layer 3 switches.​Traffic cannot be sent to two different switches, but only to two different devices like an EtherChannel-enabled server and a switch.​Traffic cannot be sent to two different switches through the same EtherChannel link.Traffic can only be sent to two different switches if EtherChannel is implemented on Gigabit Ethernet interfaces.​

What command must firstly be configured on an interface to enable layer 3 EtherChannel?Question 13Select one:switchport mode trunkswitchport access no switchportno shutdown

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?SW2(config-if-range)# channel-group 1 mode onSW2(config-if-range)# channel-group 1 mode desirableSW2(config-if-range)# channel-group 1 mode activeSW2(config-if-range)# channel-group 1 mode passive

Which channel group mode must you configure on both ports to enable a static EtherChannel?Question 10Select one:ActiveNewOnPassiveAuto

1/1

Upgrade your grade with Knowee

Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.